INFORMATION
Pay attention to hs news and learn about industry trends in real time
stainless steel mixing tank heating and cooling operation skills
Sep 05 2023
VIEWS:148
stainless steel mixing tank not only has the function of mixing, some mixing tanks also have the function of heating and cooling, we may not be very clear about these functions in the actual operation, so today to give you a unified introduction, let you know more about this knowledge.
The general use of stainless steel mixing tank is based on whether the material is heated or dried and cooled. In the customization range, the temperature needs to be below 230 ° C, and the use pressure is less than 0.1Mpa. The heating method can be determined according to the production conditions of the unit used.
There are two ways of heating such as circulation of hot oil and direct electric heating. The circulation of hot oil and other media refers to the circulation of heat conduction oil through the hot oil pump after heating to a certain temperature in the heating tank of another configuration.
Direct heating refers to the direct installation of an electric heating tube in the jacket to heat the thermal oil to the required temperature (the temperature can be adjusted according to the actual situation). The cooling cycle uses the circulation of water inside and outside the jacket, so that the material is not easily caked or sticky at a certain temperature.
In the process of unloading stainless steel mixing tank, the whole charging process should be tested and checked and supervised by special personnel. After finding material leakage, the valve should be closed for inspection and repair in time. During the discharge process, the discharge operator can not leave the discharge valve, and it is necessary to be prepared for emergencies. If a leak occurs, the discharge valve of the tank car must be closed immediately.
It is necessary to deal with the leaking cyclopentane raw materials immediately. If a small amount of leakage, it is necessary to purge the cargo with nitrogen gas and blot the cake with cotton yarn. Put it in the liquid tray and discharge the ventilation place to volatilize. If there is a large amount of leakage, it is necessary to use a special container to transfer to the empty bucket that has been prepared, and then quickly transfer to the designated storage area.
The above is the practical heating and cooling operation skills of stainless steel mixing tank in use, you can refer to and learn.
LABEL:
RECOMMENDED NEWS